|
24 / 7
|
|
|||||||||||
Беларуская
Eesti
Suomen
Français
Қазақ
Lietuvių
Latviešu
Polski
Русский
Українська
Rapid tube benders for the production of coils T-Snake
With T-Snake you can easily make any common product.
T-Snake is specialized for the production of zigzag parts: tubular heaters, etc.
|
Tube bending machine T-Snake with indication, programmable automatic clamps for linear movement and rotation of the tube in space |
|
Due to the special geometry of the T-Snake tube bender, it is possible to bend products of complex configuration on it. This expands the capabilities of manufacturers of piping or towel warmers, making it easy to manufacture products that are in demand on the market.
T-Snake uses cold mandrel and mandrelless tube bending with excellent quality.
|
flat air heater
|
three-dimensional air heater
|
Main technical characteristics:
| Parameter | Modification 300 | Modification 300X |
| Largest diameter of bent tubes | 40 mm | 57 mm |
| Smallest tube diameter | unlimited | |
| Largest bending radius | 200 mm | 350 mm |
| Smallest bending radius | is not structurally limited, it is determined by the bending technology; current standards provide 1.5 tube diameters |
|
| Length of bent tubes for mandrel bending | 3000 mm can be increased by request |
|
| Length of bending tubes with mandrelless bending | unlimited | |
| Maximum bending angle | 180° + inflection | |
| Accuracy of bending angle | 0.1° | |
| Highest torque on the bending tool shaft (N*m) | 6000 | 9000 |
| Independent shaft rotation | yes | |
| Rotation of the bending disc, movement of the mandrel, clamp, tube clamp | electro-hydraulic, electronically controlled | |
| Weight without replacement parts and oil | less than 1500 kg | |
| Power consumption Note: Depending on the modification of the machine, the power consumption may be higher (depending on the speed of the machine) |
less than 7.5 kW | |
| Oil station capacity | less than 50 L | |
| Type of oil for filling the oil station | conventional, readily and universally available hydraulic oils | |
Due to continuous improvement of machines, some technical parameters may slightly differ from those given in the table.
It is normal practice to adapt the machine to the specific requirements of a particular production.
|
|
|
+372 5853 8105 |
|
m@BaltMind.com |
© All rights reserved, 1993 - 2025.